 |
Small Sticker Application Instructions
Step 1
Clean the area thoroughly. Measure and place the sticker in the
desired location. Put a piece of masking tape on the sticker to hold
it in place.
Hint: For best results do not install the sticker in extreme heat or
cold.
|
|
|
Step 2
Lift the sticker up and peel the white paper backing off the sticker.
Be careful not to pull the masking tape off.
|
 |
Step 3
Slowly lower the sticker and rub it in place with a credit card or
similar item. |
 |
Step 4
Wait a few minutes then slowly peel the clear cover off at an angle.
Be very careful not to pull the sticker off the surface. If the
sticker pulls away from the surface repeat step 3.
|
| |
Large Sticker & Windshield Decal Instructions
|
 |
Step 1 - Clean the area thoroughly. Measure and place
the sticker in the desired location. Put a piece of masking tape on the
top of the sticker to hold it in place.
Windshield Decals - Cut into 3 parts between letters
|
 |
Step 2 - Lift the sticker up and peel the white paper backing off the
sticker. Be careful not to pull the masking tape off. Keep a hold of
the bottom of the sticker to keep it from sticking to itself or the
surface before you want it to.
Windshield Decals - Repeat step 2 & 3 for each part.
|
 |
Step 3 - Slowly lower the sticker and rub it in place
with a credit card or similar item. Start at the top middle and then the
outer edges. Firmly rub the sticker in place to make sure there is no
air trapped under the sticker. |
 |
Step 4 - Wait a few minutes then slowly peel the clear cover off at an
angle. Be very careful not to pull the sticker off the surface. If the
sticker pulls away from the surface repeat step 3. Use a pin to poke
any air bubbles in the center and push the air out through the hole.
|
